The Elecro Nano Splasher Pool Heater is and easy to install plug and play swimming pool heater.

Construction consists of a flow tube which is fitted with inlet and outlet mouldings manufactured from a specially formulated polymer alloy material. The outlet moulding accomodates a reversible flow switch with a gold tipped reed, and titanium fulcrim pin. The heater is supported on two feet, this permits either vertical wall or floor mounting. The heater control components are positioned in the top face of the casing. Screw fit adapters are supplied to allow connection to standard above ground pool flexible pipework. The water inlet and outlet fittings can facilitate connection to either metric or imperial standard pipe.

The desired pool temperature can be easily set on the Elecro Nano Heater using the panel mounted thermostat dial. Safety and equipment protection is provided by the highly reliable flow switch, Over-temperature protection is provided by the thermal cut-out.

* Fully Equipped
* Easy Installation
* Plug & Play
* Robust, durable construction
* Analogue Control With 1°c Differential
* Ultra-reliable flow switch allows safe operation with 1,000ltr/h
* Incology 825 Heating Element
* 316 Stainless Steel Flow Tube
* May be Floor or vertically wall mounted
* Safety thermal cut-out (Manual Reset)
* 2 Years Conditional Warranty

The latest Elecro EVO pool heaters have evolved from the 800 Series. These units come fully equipped and pre-wired including a super sensitive flow switch, that allows safe coupling to Intex, Costco, Macro and Argos type splasher pools. They also come complete with a control thermostat, safety thermostat and integral contactor relay.

The heaters are very easy to install, requiring only final connection to a mandatory separate RCD.No pump interterlock is required. All heaters come fitted with 1½" BSP female threaded adapters for easy connection to all pipework. All heaters are supplied with hose tail adapters for connection to flexible pipework, and heater sizes 12-kW through to 18-kW are also supplied with 1½" BSP unions for connection to rigid pipework.

A heating system that can pay for itself in one season. By investing in an El Nino solar heating system you can expect to increase your pool temperature by approx 7-10°c throughout the summer.


Splasher type swimming pools have the same requirements as any other pool, they all need heat. By investing in an El Nino solar heating system you can expect to increase your pool temperature by approx 7-10°c throughout the summer. In addition to enhancing the bathing experience, El Nino is also an economical and environmentally friendly investment. The expensive alternative is using domestic electricity (3kw electric heater - approx 30p per hour running cost) to achieve a comfortable bathing temperature.
A heating system that pays for itself I none year
Suitable for all splasher pools
Heats water to a pleasant temperature
Low weight, simple to use and repairable
Easy to stow away when not in use
No complicated installation - it uses the existing filter pump
Economical and environmentally friendly way to heat the pool

Please Note: A 'Basic Kit' includes the solar collector unit (2pcs of solar collectors) and coupling devices to connect the solar collectors to the pool. The only thing needed in addition to the basic kit is a few metres of ordinary garden hose.

Basic Kit is suitable for pools up to 7m2. For larger pools, the system is easily increased by adding more basic kits or an expansion kit.